Laboratory Bench Frame Specifications: What to Put in the Drawing

The frame determines whether a bench stays level, carries the instrument, and gives you somewhere to run services. It should be specified explicitly, not left to the supplier's standard.

Frame types and when each is used

C-frameOpen knee space, easy to clean underneath, common for general chemistry and teaching labs. Best where seated work and under-bench access matter.
H-frameGreater lateral stability and higher load capacity. Suited to heavy instruments, long island benches and mobile equipment.
CantileverFrame hung from a wall or central spine with no front legs. Maximum floor clearance, but requires a verified structural fixing to the building.

Steel, gauge and finish

Specify the steel type, tube or sheet gauge, weld finish and coating system. For wet areas, stainless steel or a well-sealed powder coat over pre-treated steel is worth the cost. Ask what surface preparation is used before coating — that detail determines how long the finish survives.

Levelling and loads

Adjustable feet are essential on any floor that is not perfectly flat. State the anticipated point load, especially for balance benches, centrifuges and heavy analytical instruments; these should be quoted as separate items with their own frame specification.

Worktops and edges

Phenolic, epoxy resin, ceramic and stainless worktops behave differently under heat, solvents and impact. Specify material, thickness, edge profile (marine edge, raised lip or flat) and joint details. Confirm the chemical resistance data against the chemicals actually used.

Service routing

Show gas, water, power and drainage positions on the shop drawing, plus the service spine or void that carries them. Services fixed after production are the most common cause of site rework.

Common questions

Questions Buyers Ask

Which frame should we choose for a teaching lab?

A C-frame is usual: it gives seated knee space and is straightforward to keep clean. Use an H-frame where heavy instruments or long spans are involved.

Do you build to our dimensions?

Yes. Benches are built to the room drawing rather than cut down from catalogue sizes.

Can you supply dimensional shop drawings?

Yes, for approval before production, showing service positions and fixing details.

Related

Keep Reading

Specifying a project now?

Send the drawings or BOQ and we will return a price direction, a lead time and the questions our engineering team needs answered.

Request a Project Quotation
WhatsApp